The MultiSpread™ 320 is Earth & Turf’s largest tow behind compost spreader. It’s perfect for spreading compost, sand, topsoil and other topdressing materials

This commercial sized, tow behind compost spreader uses a wide spread beater design for its application system. The Model 320 spreads wet and dry material in various widths, averaging 60″ with most materials. It’s designed to carry 27 cu. ft. of sand (Or 2,700 lbs. of sand). The Light-Material Sides™ increase its capacity to 2 cu. yds. (or 54 cu. ft.) for lighter materials but the Light-Material Sides cannot be used with sand as this would exceed the weight capacity of the machine and would void the warranty. 

The MultiSpread 320™ is available in two-wheel ground-drive or hydraulic drive versions. The spreader utilizes a “widespread beater” system and will spread wet or dry material in patterns up to 72 in. wide. It is most commonly used to spread compost and other lighter topdressing materials but it does work well to spread sand on golf courses. This is a big brother machine to the MultiSpread 220 top dresser from Earth & Turf. 

Ground Drive System:

Dual wheel ground drive system runs belt and beaters off wheel speed, allowing consistent spread at various speeds.

Widespread Beater:

Our patented "Widespread Beater" is designed to spread a variety of wet or dry materials up to 72" wide.

Adjustable Lever:

The engagement lever is adjustable to facilitate ease of use by the operator.

Belt:

A PVC belt delivers material evenly and smoothly to the "widespread beater."

Adjustable Belt:

The belt is easily adjustable by loosening four nuts on the conveyor roller slide on each side and then adjusted by using a single bolt and nut system on each side.

Adjustable Tongue:

The tongue has five adjustment holes to accommodate a variety of towing vehicles. The hitch pivots to ensure the unit follows the contour of the turf.

Rear Shroud:

The rear shroud is adjustable in four different positions to adjust material spread for varying conditions*
(Adjustable wing kit option available to control spread width)

Light Material Sides:

Increase the capacity to just above 1 cu. yd. These are designed for use with lightweight materials such as compost, crumbed rubber, and calcined clay. Fully loaded weight should not exceed 2,000 lbs.

Wing Kit:

The optional wing kit allows operators to control the spread pattern by moving one or both wings inward.

Loading Chutes:

The optional loading chutes increase the loading width from 73 inches (standard width) to 85 inches. These loading chutes reduce spillage when loading with a tractor or skid steer.